![]() ![]() ![]() You should be able to cut your aluminum metal piece within 30 seconds.At this point, you should easily be able to snap it into 2 pieces with your hands. Continue striking the metal until there is a notch in it. Use a ball-peen hammer to strike the chisel's handle and always cut perpendicular to the jaws of the vice. Hold the chisel tip against the metal-perpendicular to it-with your non-dominant hand. This article has been viewed 421,400 times.Īlign the chisel with your vice's screw and hammer the aluminum. In this case, several readers have written to tell us that this article was helpful to them, earning it our reader-approved status. WikiHow marks an article as reader-approved once it receives enough positive feedback. There are 10 references cited in this article, which can be found at the bottom of the page. Himesh is passionate about educating the public about the minerals industry. He received his MS in Metallurgical Engineering from the University of Nevada, Reno, and a Dual Degree in Mineral Engineering from the Indian Institute of Technology (Indian School of Mines), Dhanbad. With over five years of industry and graduate research experience in the raw materials industry, Himesh has extensive knowledge of mining and mineral extraction and recovery methods, mine financing, and the environmental impacts of mining. Himesh Patel is a Metallurgical Engineer at Mcclelland Laboratories in Reno, Nevada. This article was co-authored by Himesh Patel. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |